Turn-in, bleed and lid clearance explained
Four small allowances decide whether a rigid box looks clean and closes well: turn-in, bleed, corner ears and lid clearance.
Turn-in
Turn-in is the strip of wrap paper that folds over the top edge of a wall and sticks to the inside. It hides the raw board edge.
A turn-in of about 15 mm is common on 2 mm board. It has to be shorter than the inside wall height, so shallow lids need less. Too little turn-in can lift at the edge; more than you need only wastes paper.
Bleed
Bleed is extra printed area outside the cut line. Cutting is never perfectly placed, so artwork that stops exactly at the cut line can leave a thin unprinted edge. Extending backgrounds about 3 mm past the cut line avoids that.
Bleed applies to the wrap paper, not the greyboard, because only the paper is printed.
Corner ears
Corner ears are the small tabs on the long-side flaps of the wrap paper. They wrap round each corner onto the short walls, and the short-side flaps then cover them. This keeps board from showing at the corners.
Ears of 10 to 15 mm suit most small and medium boxes. Each ear must be less than half the box width, or the two ears on one wall would overlap.
Lid clearance
Lid clearance is the gap that lets the lid slide over the base. The lid board is cut slightly larger than the finished base on every side.
About 1 mm per side on the board is a good starting point. The wrap paper on the base and the turn-in inside the lid each take up one paper thickness, so the free gap you feel is smaller than the number you enter. With 170 gsm paper, 1 mm per side leaves roughly 0.6 to 0.7 mm of real gap.
- Too tight: the lid sticks or scuffs the print. Increase the clearance, especially with laminated or thick paper.
- Too loose: the lid rattles or drops too fast. Reduce the clearance.
Check with a sample
These values are starting points. Board, paper, glue and machines all vary, so make one sample and adjust before a production run. The two piece rigid box dieline tool lets you change each allowance and shows an estimate of the lid fit for your paper weight.