Drawer box dieline

Free dieline template for drawer boxes, also called slide boxes or matchbox style rigid boxes. The sleeve is sized around your tray.

Box size

Size is for the tray. The sleeve is sized around it, and the tray slides out along its length.

Board
Drawer and sleeve
Wrap paper
CutScore / V-groove (board), fold (paper)Ribbon hole or thumb notchBleed: artwork extends to here
      Cut list
      PartFlat cut size (mm)Finished size (mm)Prints 1:1 on

      Need this made?

      Nivaraprint makes rigid boxes, mono cartons and luxury boxes in Mumbai. Send this exact job for a quote. Your sizes and options are added to the message for you.

      How to use this drawer box dieline

      A drawer box has two parts: a wrapped tray that holds the product, and a sleeve that the tray slides into. This tool draws four parts: tray board, tray wrap, sleeve board and sleeve wrap.

      The sleeve is one board with three V-grooves. Fold it into a tube and tape the open corner, then wrap it and turn the paper into both open ends. The tray is made like the base of any rigid box.

      Sleeve clearance is the free space on each side of the tray inside the sleeve. Both parts get thicker once they are wrapped, so 1 mm per side is a safe start. Use more for laminated paper.

      Choose a ribbon pull (a hole in the front wall of the tray) or a thumb notch (a half round cut in the sleeve). Make one sample to check the slide before a production run. More styles are in types of rigid boxes.

      Common questions

      Is the size for the tray or the sleeve?

      For the tray. Enter the inside size of the tray, or switch to outside size. The sleeve is worked out from the tray, the board thickness and the clearance.

      How much sleeve clearance should I use?

      1 mm per side suits most wrap papers. Under 0.5 mm will usually be tight after wrapping, and over 2 mm lets the drawer slide out on its own.

      Which direction does the drawer slide?

      Along its length, so the sleeve is open at the two short ends. Swap length and width if you want it to slide the other way.

      Ribbon pull or thumb notch?

      A ribbon gives a premium look and works on any size. A thumb notch costs less and suits shallow boxes where the wall is too short for a ribbon hole.

      Can I open the file in Illustrator or CorelDRAW?

      Yes. The SVG opens in both with cut, score and bleed lines in separate groups and colours. The PDF is at 1:1 scale for printing and checking.

      Is the dieline ready for production?

      It is drawn to your numbers with standard allowances, but board, paper and machines vary. Make one plain sample and adjust before a production run.

      More free dieline tools