Straight tuck end box dieline

Free dieline template for straight tuck end (STE) cartons. Both closure panels hinge from the back, so the front panel has no raw edge.

Carton size

Length is the front panel, width is the side panel (depth), height is the standing height. Sizes are measured crease to crease.

Closure style

Flaps and print
CutCrease (score) lineBleed: artwork extends to here
      Cut list
      PartFlat cut size (mm)Finished size (mm)Prints 1:1 on

      Need this made?

      Nivaraprint makes rigid boxes, mono cartons and luxury boxes in Mumbai. Send this exact job for a quote. Your sizes and options are added to the message for you.

      How to use this straight tuck end dieline

      On a straight tuck end carton the top and bottom closure panels both hinge from the back panel and tuck in behind the front. The cut edges stay at the back, which is why this style is used for cosmetics, electronics and retail packs with a window.

      Each end has two dust flaps that fold in first, then the closure panel with its tuck flap. No glue is needed apart from the side seam.

      Straight tuck end blanks nest less tightly on the print sheet than reverse tuck end blanks, so they use a little more board. For heavy products use a snap lock bottom.

      Sizes are crease to crease. Print at 100%, check the 50 mm bar, and fold one plain sample before making a die.

      Common questions

      What is the difference between straight tuck and reverse tuck?

      On a straight tuck end both tucks fold from the same panel, the back. On a reverse tuck end the top tuck folds from the back and the bottom tuck from the front. Straight tuck looks cleaner from the front; reverse tuck uses less board.

      How long should the tuck flap be?

      12 to 20 mm suits most cartons. Under 10 mm can pull out easily, and the two tucks must not meet inside the carton.

      Does a straight tuck end box need glue?

      Only on the side seam, which is glued when the carton is made. The ends close by tucking.

      Can I open the file in Illustrator or CorelDRAW?

      Yes. The SVG opens in both with cut, score and bleed lines in separate groups and colours. The PDF is at 1:1 scale for printing and checking.

      Is the dieline ready for production?

      It is drawn to your numbers with standard allowances, but board, paper and machines vary. Make one plain sample and adjust before a production run.

      More free dieline tools