Magnetic box dieline

Free dieline template for magnetic closure rigid boxes (book style box with a front flap). Magnet positions are marked for you.

Box size

Size is for the tray that holds the product. The case (base, spine, lid, flap) is sized around it.

Board and case
Wrap paper
CutScore / V-groove (board), fold (paper)Magnet positionBleed: artwork extends to here
      Cut list
      PartFlat cut size (mm)Finished size (mm)Prints 1:1 on

      Need this made?

      Nivaraprint makes rigid boxes, mono cartons and luxury boxes in Mumbai. Send this exact job for a quote. Your sizes and options are added to the message for you.

      How to use this magnetic box dieline

      A magnetic closure box is a wrapped tray glued into a case. The case is four greyboard panels (front flap, lid, spine and base) joined by one sheet of cover paper, with a liner paper inside. This tool draws five parts: tray board, tray wrap, case board, cover paper and liner paper.

      Magnets sit in the front flap and in the front wall of the tray, at the same distance from each end, so they meet when the lid closes. The circles on the drawing show where to recess them. Check the polarity of every pair before you glue the paper over them.

      The gaps between the case boards are the hinges. A wider gap gives an easier fold; a narrow gap makes the lid spring open. 5 mm suits 2 mm board with most cover papers.

      Print the PDF at 100%, measure the 50 mm check bar, and make one sample before a production run. See types of rigid boxes for how this style compares with the others.

      Common questions

      Where do the magnets go?

      One set goes in the front flap of the case and the matching set in the front wall of the tray, under the wrap paper. The drawing marks each centre and gives its distance below the rim. Check that each pair attracts before gluing.

      What size magnets should I use?

      Disc magnets of 10 mm diameter and 1 to 2 mm thick are common for small and medium boxes. Use two per side, and three or more on boxes longer than about 300 mm.

      What is the flap height?

      It is how far the front flap comes down the front of the box, as a percentage of the box height. 100% covers the whole front. A shorter flap leaves part of the tray showing.

      What hinge gap should I use?

      About 5 mm between the case boards for 2 mm board. Add 1 mm for thick or laminated cover paper, because the paper needs room to fold.

      Can I open the file in Illustrator or CorelDRAW?

      Yes. The SVG opens in both with cut, score and bleed lines in separate groups and colours. The PDF is at 1:1 scale for printing and checking.

      Is the dieline ready for production?

      It is drawn to your numbers with standard allowances, but board, paper and machines vary. Make one plain sample and adjust before a production run.

      More free dieline tools