Folding carton styles
A folding carton, called a mono carton in India, is a box cut from one sheet of paperboard and glued on one side seam. The body is always four panels and a glue flap. What changes from style to style is how the top and bottom close.
Reverse tuck end (RTE)
The top closure hinges from the back panel and the bottom closure from the front. Because the two ends face opposite ways, blanks fit closely together on the print sheet, so this is the cheapest tuck carton. It is the standard box for medicines, tubes and small goods.
Draw one with the reverse tuck end box dieline tool.
Straight tuck end (STE)
Both closures hinge from the back panel. The cut edges are hidden at the back, so the front looks cleaner. Choose it for cosmetics, retail packs and cartons with a window on the front.
Draw one with the straight tuck end box dieline tool.
Snap lock bottom (1-2-3 bottom)
The top is a tuck, and the bottom is four flaps that lock into each other by hand in three moves. No glue is needed and the base holds much more weight than a tuck. Use it for bottles, jars and candles.
Draw one with the snap lock bottom box dieline tool.
Seal end carton
Both ends are closed by glued flaps. This is the cereal box. It is strong and tamper evident, and is normally filled and sealed on a machine.
Draw one with the cereal box dieline tool.
Crash lock (auto) bottom
The bottom is pre-glued by the carton maker and pops into place when the carton is opened. It is the fastest to set up and is used on high volume lines. It needs a more complex die and gluing, so it is not drawn by the tools on this site yet.
Quick comparison
| Style | Closes with | Best for |
|---|---|---|
| Reverse tuck end | Tucks, no glue | Light products at the lowest cost |
| Straight tuck end | Tucks, no glue | A clean front panel |
| Snap lock bottom | Hand locked base, tuck top | Heavier products |
| Seal end | Glue at both ends | Machine packed dry goods |
How carton sizes are written
Length × width × height, measured from crease to crease. Length is the front panel, width is the side panel (the depth), and height is the standing height. Allow 1 to 2 mm more than the product in each direction. If you are new to dielines, start with what is a dieline template?